|
| BELLOWS | |
| COMPRESSION RING | |
| (6) 1/4-20 BOLTS | |
| SNAP-TIGHT BODY | |
| (6) 1/4-20 BOLTS | |
| DRAIN VALVE |
| TO FIGURE THE RISER LENGTH, TAKE THE DIMENSIONS ABOVE AND SUBTRACT FROM THE TOP OF TANK. KEEP IN MIND THAT IT SHOULD ONLY BE ABOVE GRADE TO KEEP WATER FROM PUDDLING. CNI RECOMMENDS 1/2" TO 1" ABOVE GRADE | |
| TAKE THE RISER FLANGE-(A) AND TIGHTEN TO RISER | |
| REMOVE THE FLANGE COMPRESSION RING-(C), TAKE THE BELLOWS-(B) AND SIT ON FLANGE-(A). MAKE SURE THE "O"-RING IS NOT SHOWING | |
| NOW LAY COMPRESSION RING IN PLACE SCREW THE 1/4-20 BOLTS-(D) ALTERNATING BACK AND FORTH TIGHTENING EACH TIME. | |
| BACK FILL UP TO THE NECK OF THE BELLOWS TO ALLOW SEAT FOR THE S/T BODY TO SIT ON. THERE IS A 2 1/2" ADJUSTMENT IN THIS AREA. | |
| NOW YOU CAN SET THE BODY IN PLACE AND PLUMB. | |
| AGAIN YOU'LL FOLLOW THE SAME TIGHTENING PATTERN OF ALTERNATING THE 1/4-20 BOLTS. | |
| SCREW DOWN DRAIN VALVE-(G), UNTIL IT SEATS ON "O"-RING. |
 Home |
Back |
|
Part 2 |
Order |
|---|